44540 Exposure Head Interface EHI: Unexpected software failure Gravure Japanese_Newspaper_OEM_Engine Lotem_Quantum Magnus_400 Magnus_800 Magnus_VLF Slave_MCE_Firmware Thermoflex Think_Motion_Controller Trendsetter_400/800 Trendsetter_NEWS Trendsetter_Series_4 When the exposure head interface encounters an unexpected error, the firmware will crash with this error code. If possible, the system will dump the filename and line number. Return this information to the firmware developer for analysis and attempt to determine the sequence of events that caused the error. In order to continue, the system may need to be reset. It may be required to avoid the sequence of events that caused the error to prevent re-occurrences of the error. A device error has occurred: You may be able to continue by pressing the "resume" button onscreen (if present) or by resetting the device and workstation. For support under your service contract, contact the Creo Response Center at 1-(800) 472-2727 or online at http:\\eCentral.creo.com (or your local service representative) To speed troubleshooting, please make a note of error numbers, the media type/size and any information about the workflow or job that might be relevant. This error is reported. An unexpected error in the exposure head interface. 26-Mar-2002 ..\..\ShowAllErrors.htmFirmware 1 Error Index ..\..\ShowAllCommands.htmFirmware 1 Command Index ..\..\ShowAllParameters.htmFirmware 1 Parameter Index Updated: Thu Jul 17 07:23:40 2008 PST